Next: 3.2.2 Existence of a Up: 3.2 Point Source Sensitivity Previous: 3.2 Point Source Sensitivity

### 3.2.1 Flux of a Source - Gaussian Statistics Case

This is the most useful case as in general not just a detection, but a measurement of the flux (or upper limit on the flux) of a source is required.

On-axis, the signal to noise ratio is given by:

 Ksnr = Nsrc/var(Ntot) (5)

where Nsrc is the number of source counts, and var(Ntot) is the variance in the total counts (source + background) and is typically given by var(Ntot) = Nsrc + Nb, which assumes no uncertainty in the background.

The minimum detectable source count rate corresponding to a particular signal to noise ratio is given by the relationship

 Rmint = K2snr/2 + K2snr/2 + K2snrRbt (6)

where Rmin denotes the minimum detectable source count rate, Rb the total background rate in the detection cell, t the observation time, and Ksnr the desired signal to noise ratio (snr) on the flux measurement. This is derived by combining the equations defining the snr and variance, and using the additional relation, counts = rate x time. The standard estimate of Rb uses the last entry of Table 5, 1.1 x 10-6 counts s-1 arcsec-2, multiplied by the area of the detection cell (in arcsec2).

Given a desired s/n and a countrate, one can also solve for the time required to achieve a particular s/n for a particular source:

t = K2snr1/R + Rb/R2

where R is the countrate of the source.

As an illustrative example (see Figure 28), we show the point source sensitivity for Ksnr = 5 versus observing time for a source with a power law spectrum.

That is, we assume a point source with a power law spectrum of energy index 0.5 similar to the extragalactic X-ray background. A hydrogen column density of 5 x 1020 cm-2 is used. Notice that the sensitivity increases linearly with observing time for short observations where there are virtually no background counts in the detection cell. For observations that are long enough for background to be significant, longer than about 105 s, the sensitivity increases only as the square root of the observation time.

In general, the conversion from HRI counts to energy flux depends on the spectrum of the X-ray source. For the power law spectrum characterized by the parameters given above, this conversion is given by: 1 count s -1 = 1.06 x 10-10 erg cm-2 s-1 in the energy band 0.1 to 2.4 keV. The following section discusses the conversion from energy flux to count rate in more detail.

Off-axis, sensitivity estimates must take into account the cell size from the off-axis PSF (cf. Section 2.2). The cell size can be taken as the 50% power radius, i.e., a square region where 50% of the source counts will fall. The background rates must also be scaled to the new cell size.

The vignetting correction in Figure 14 (Section 2.3.2) can be used to scale down the number of counts detected from off-axis sources due to the decrease in telescope area; since the HRI field of view is limited, the slight energy dependence of the vignetting correction can usually be neglected for feasibility purposes.

Next: 3.2.2 Existence of a Up: 3.2 Point Source Sensitivity Previous: 3.2 Point Source Sensitivity
rsdc@cfa.harvard.edu
1999-05-25